Carefully assemble the top and bottom of the case. Use the supplied screws to secure both sides of the drive 13. Attach the provided IDE ribbon cable and to the main board, in place of the Disconnect the Molex to SATA cable and then replace the drive tray and insert the screws. Unscrew the four screws holding the drive tray in place and remove the drive tray. Hold the base of the drive enclosure and pull the bridgeboard up to disconnect it. Disconnect the SATA Data cable from the bridgeboard.
If you are using a SATA hard drive continue to Step 4, i
Ensure that the NAS Enclosure is disconnected from the mains, before removing the 4 screws from the bottom of the case 2.
#2010 mac mini remove hard drive manual#
Consult your hard disk manual or the manufacturer’s website for the correct jumper setting. User Manual English Hardware Assembly Before starting the assembly make sure the jumper(s) on your hard drive are set to the Master setting. Features For use with standard 3.5” SATA/IDE hard disks USB 2.0 and RJ. The small footprint design allows it to be seated underneath a Mac Mini, but with its Network and USB 2.0 interface, it can also be used with other suitably equipped Macs and PCs. This enclosure has been designed to add extra storage to your Mac Mini and your network, whilst complimenting the design of your Mac Mini. User Manual English Introduction Thank you for purchasing the LINDY Mini NAS Enclosure. Mini NAS Enclosure SATA & IDE User Manual English LINDY No.
0 kommentar(er)
